Jinan Audi special maintenance knowledge summary:

一、動機冷卻液液面檢查發動機在熱機狀態時，千萬不要打開散熱器蓋，否則可能會被濺出的冷卻液或高溫蒸氣燙傷。等發動機冷卻后，檢查冷卻液的液面應處于滿位和低位之間，否則應加蒸餾水或純凈水(不能加礦泉水)或冷凍液，加水后的液面高度不能超過滿位。如發現短時間內冷卻液減少的很快，應檢查冷卻系統是否有泄漏或到維修站去檢查。

1、 Check the coolant level of the engine. When the engine is hot, do not open the radiator cap, otherwise you may be scalded by the splashed coolant or high-temperature steam. After the engine is cooled, check that the liquid level of the coolant should be between the full level and the low level, otherwise distilled water or purified water (mineral water cannot be added) or refrigerant should be added, and the liquid level after adding water should not exceed the full level. If it is found that the coolant decreases rapidly in a short time, check the cooling system for leakage or go to the maintenance station for inspection.

二、 離合器總泵液面的檢查離合器液面介于高、低液面間則表示正常，如果低于標準線，則可能是總泵或分泵皮碗損壞。在發動機運行狀態下將出現掛檔難或無法掛檔的現象，請即時到就近的維修站檢修。

2、 Inspection of clutch master cylinder liquid level. If the clutch liquid level is between high and low, it indicates that it is normal. If it is lower than the standard line, the master cylinder or slave cylinder cup may be damaged. It will be difficult or impossible to shift when the engine is running. Please go to the nearest maintenance station for maintenance immediately.

三、 輪胎的檢查每月應在常溫下檢查一下輪胎氣壓，如果低于正常標準應及時補充輪胎氣壓。氣壓不能過高或過低，否則影響駕駛的性。

3、 Check the tire pressure at normal temperature every month. If it is lower than the normal standard, supplement the tire pressure in time. The air pressure should not be too high or too low, otherwise the driving safety will be affected.

檢查輪胎的龜裂情況，存在隱患時應及時更換輪胎。

Check the cracking of the tire. If there are potential safety hazards, replace the tire in time.

選用輪胎時，應使之型號一致。

When selecting tires, the models shall be consistent.

四、 空氣濾清器的檢查空氣濾清器過臟會引起發動機工作不良、油耗過大，損壞發動機等，檢查空氣濾清器時，若發現灰塵較少，堵塞較輕，可用高壓空氣從內向外吹凈，繼續使用。過臟的空氣濾清器應及時更換。

4、 Inspection of air filter dirty air filter will cause poor engine operation, excessive fuel consumption and damage to the engine. When inspecting the air filter, if less dust and light blockage are found, high-pressure air can be used to blow it from inside to outside and continue to use. The dirty air filter should be replaced in time.

五、 檢查汽油濾清器若發現供油不暢應檢查汽油濾清器是否堵塞，如異物堵塞應及時更換。

5、 Check the gasoline filter. If it is found that the oil supply is not smooth, check whether the gasoline filter is blocked. If it is blocked by foreign matters, replace it in time.

以上這些內容就是關于濟南奧迪專修http://www.jnrunao.com的相關內容，如果您想要了解更多內容，歡迎聯系在線客服，我們必將竭誠為您服務。

The above contents are about Jinan Audi specialty http://www.jnrunao.com If you want to know more, please contact online customer service, and we will serve you wholeheartedly.